• QUESTIONS? GIVE US A CALL! 1 (877) 293-0784

Navigate to the Spycor Environmental homepage

-
You are here:Home > Dust Containment > Poly Hangers
POLY-HANGER 1 Supports one or more layers of poly in front of walls. Hanger 1 slips behind wall molding and is supported by the vertical leg of the molding. Hanger 1 will also support poly in front of masonry or paneling by nailing into a joint which can
POLY-HANGER 1 Supports one or more layers of poly in front of walls. Hanger 1 slips behind wall molding and is supported by the vertical leg of the molding. Hanger 1 will also support poly in front of masonry or paneling by nailing into a joint which can - Image 1 of 0
POLY-HANGER 1 Supports one or more layers of poly in front of walls. Hanger 1 slips behind wall molding and is supported by the vertical leg of the molding. Hanger 1 will also support poly in front of masonry or paneling by nailing into a joint which can - Image 2 of 0
POLY-HANGER 1 Supports one or more layers of poly in front of walls. Hanger 1 slips behind wall molding and is supported by the vertical leg of the molding. Hanger 1 will also support poly in front of masonry or paneling by nailing into a joint which can - Image 1 of 0
POLY-HANGER 1 Supports one or more layers of poly in front of walls. Hanger 1 slips behind wall molding and is supported by the vertical leg of the molding. Hanger 1 will also support poly in front of masonry or paneling by nailing into a joint which can - Image 2 of 0
POLY-HANGER 1 Supports one or more layers of poly in front of walls. Hanger 1 slips behind wall molding and is supported by the vertical leg of the molding. Hanger 1 will also support poly in front of masonry or paneling by nailing into a joint which can - Image 1 of 0
POLY-HANGER 1 Supports one or more layers of poly in front of walls. Hanger 1 slips behind wall molding and is supported by the vertical leg of the molding. Hanger 1 will also support poly in front of masonry or paneling by nailing into a joint which can - Image 2 of 0

POLY-HANGER # 1 (Box 100)

Poly Hangers
0 Reviews
$0.00
Product Code: PH1
Supports one or more layers of poly in front of walls. Hanger 1 slips behind wall molding and is supported by the vertical leg of the molding. Hanger 1 will also support poly in front of masonry or paneling by nailing into a joint which can be easily patched after tear down.
  • Eliminates damage to wall
    surfaces
  • Simple to install, remove and
    reuse on the next job
  • Increases production of
    hanging poly sheeting

  • Eliminates using spray glue to
    support poly sheeting

  • Prevents poly from falling down

    • Installation Instructions:

    Install Hangers approximately 3' apart. Hang the poly sheeting on the prong keeping the top of the poly just below the wall molding. Complete the containment by taping between the poly and the molding and by taping over the prong.

    Hanger 1 can be used to support poly in front of masonry by nailing in a joint using a tension pin (i.e., tempered steel molding nail available at drywall supply houses).

    Poly Hanger 1 is removed by gently pulling down on the outer tip of the wall molding which causes the back vertical leg to rotate away from the wall and Hanger 1 can be slid downward.


    Reviews

    Write a review.
    Average Customer Review:
    ( 0 )